Callaway 200 S Manual - User Manual

Download PDF User Manual

Full Text Searchable PDF User Manual

200

LASER RANGEFINDER

Product

Callaway 200 S Laser Rangefinder

Model

200 S

Dimensions

3.74” x 2.80” x 1.57”

Weight

4.4 oz. (125g) (Without Battery)

Battery

CR2 3 -Volt Lithium Battery

Display

LCD display

Magnification

Max Range

5-800 yd

Range To Flag

5-275 yd

Accuracy

+/- 1 yd

Slope Measurement Range -89° - 90°
Unit of Measure

Yards/Meters

Water/Fog Proof

Weather Resistant (IPX3)

SPECIFICATIONS

INTRODUCTION

Thank You for choosing the

Callaway 200 S Laser Rangefinder

featuring

P.A.T. (Pin Acquisition Technology) and Slope Mode

Designed to deliver precise distance measurements,

P.A.T.

locks

onto the flagstick up to 275 yards away, ensuring accuracy even

when trees and other objects are in the background.

INTRODUCTION

BATTERY INSTALLATION

Lift hatch tab.

Turn counterclockwise to open.

Remove protective plastic battery cover.

Replace battery cap & tighten by turning clockwise.

NOTE:

If the

Low Battery Icon

is present on LCD display, there are

approximately 200 ranges left until the battery is completely drained.

The

Low Battery Icon

will flash if the battery life is very low. In this

case, the battery needs to be replaced before next use.

ENGLISH

INCLUDES

CR2 - 3-Volt Lithium Battery

Carry Case

Cleaning Cloth

RANGEFINDER DIAGRAM

Eye Piece

Diopter Adjustment

Power Button

Battery Door

LCD DISPLAY

Zero-In Aiming Square

Laser Indicator Box

P.A.T. Mode Indicator

Distance

Unit of Measure

Low Battery

Slope Adjusted Distance

HOW TO USE

164

ENGLISH

HOW TO USE

While looking through the

Eye

Piece

PRESS

and

RELEASE

the

Power Button

. The rangefinder is

now powered on.

To focus/increase clarity, use the

Diopter Adjustment

by turning

the

Eye Piece

Continue looking through the

Eye Piece

, aim the

Zero-In Aiming

Square

at your intended target and

PRESS

the

Power Button

. The

laser will fire and the

Laser Indicator

Box

will appear around the

Zero-In

Aiming Square

. The measurement

will be displayed at the top of the LCD

display.

164

MEASUREMENT MODES

Standard

- Standard Mode is recommended when measuring

distances to larger objects.

(Fig. A)

P.A.T. (Pin Acquisition Technology)

- P.A.T. Mode is best used

when measuring the distance to a flagstick or smaller objects. To

toggle between Standard and P.A.T Mode, quickly

PRESS

the

Power Button Twice

while device is powered on. When P.A.T.

Mode is activated, the flagstick icon will appear on the left side of

the LCD display.

(Fig. B)

Scanning

- To measure distances to multiple targets in succession,

PRESS & RELEASE

the

Power Button

to power on.

Then

HOLD

Power Button

, the

Laser Indicator Box

will flash and the laser

will continuously fire. Measurements will change as you scan the

landscape and change targets.

NOTE:

While scanning in P.A.T. Mode, the measurement will only

change when a shorter distance is measured. This is useful when

measuring the distance to a flagstick when there are trees or other

objects in the background.

HOW TO USE

ENGLISH

Slope Mode

- Device will measure the angle of incline/decline

(Fig. B)

then calculate and display the slope adjusted distance in the bottom

right of the LCD display.

(Fig. C)

•

To turn Slope Measurement On/Off:

NOTE:

The slope measurement & adjusted yardage will appear in

the bottom right corner of the LCD display when the function is enabled

With the unit off,

HOLD

the

Power Button

for

three seconds

until the slope function appears in the bottom right corner of the

LCD display. Once the slope function appears,

RELEASE

the

Power Button

Repeat this process if you need to turn The Slope Measurement

off. The Slope function will not appear unless enabled.

Unit of Measure

- To change the unit of measure from Yards to

Meters, start with the device powered off. Then

HOLD

the

Power

Button

for 5 sec. The unit of measure is indicated by a “

” or “

”

shown directly to the right of the distance displayed.

TROUBLESHOOTING

Rangefinder is consistently providing inaccurate measurements.

• Make sure the device is set to the desired unit of measure

(Yards or Meters).

• Weak battery signal can affect the accuracy of the device. If the

Low Battery Indicator

is present on the LCD display, replace

the battery.

• Make sure there isn’t anything obstructing your view such as

leaves, branches, your finger, etc.

OPERATIONAL NOTES

The maximum measurement range is 5-800 yards to objects and

5-275 yards to a flagstick with +/- 1 yard accuracy.

NOTE:

Maximum range can depend on several factors, including

target characteristics and environmental conditions. For instance,

longer maximum distances may be obtained to targets that are

large in size, brightly colored, or have a reflective finish. Ranging

capability can also be affected by the angle to the target and

lighting conditions.

Auto Shutoff -

To conserve battery life, the device will

automatically power off when idle for more than 5 seconds.

Weather Conditions -

Heavy rain and thick fog can potentially

limit the maximum range of the device.

Weather Resistant -

Protected against light rain.

MAINTENANCE

To clean, use only a soft, clean cloth to prevent scratches.

Do not submerge in liquid or apply any cleaning products.

Do not store in extremely hot/cold temperatures (<50°F - >110° F).

Store in carrying case when not in use.

ENGLISH

TROUBLESHOOTING

(CONTINUED)

When looking through the Eye Piece, the view is blurry.

• Use the Diopter Adjustment by turning the

Eye Piece

to focus/

increase clarity.

• Make sure there isn’t anything obstructing your view such as

leaves, branches, your finger, etc.

• Use a soft, clean cloth to clean lens.

When should the battery be replaced?

• If the

Low Battery Indicator

is present on the LCD display.

•

If the rangefinder is consistently providing inaccurate

measurements.

• If the LCD display is not present when

PRESSING

the

Power Button

What type of battery does the rangefinder use?

• CR2 3-Volt Lithium Battery.

When should P.A.T. Mode be used?

• When measuring the distance to smaller targets such as

a flagstick.

• When scanning the landscape to measure distances to a smaller

target such as a flagstick and there are trees or other objects in

the background.

If you have any other questions or concerns,

please call 1-888-606-4634 or go to www.callawaydmd.com.

WARNING

•

NEVER

look directly into the sun or intense light when using

the laser rangefinder.

•

DO NOT

aim/point laser rangefinder at another person.

•

DO NOT

aim/point laser rangefinder at anyone’s eyes or face.

•

DO NOT

attempt to disassemble the laser rangefinder.

•

DO NOT

submerge in any liquid.

•

DO NOT

store the laser rangefinder in extreme cold/hot

temperatures (<50°F - >110°F).

WARRANTY / WARNING

WARRANTY POLICY

This product is warranted to be free from defects for up to (1) year

from the original purchase date. IZZO Golf cannot refund your

purchase unless purchased directly from IZZO Golf. IZZO Golf will

replace or repair any unit that is determined defective under normal

use within the warranty period. Please call Customer Service at

888-606-4634

to request a Return Authorization. All defective

products must be returned to:

IZZO Golf

Attn: Returns Dept.

1635 Commons Parkway

Macedon, NY 14502

Please include a note with your Name, Address, Phone # and the

Return Authorization #.Your replacement will be shipped once we

diagnose the returned unit.

Callaway Golf and the

Chevron device are trademarks of Callaway Golf Company.

IZZO Golf is an official licensee of Callaway Golf Company.